How to setup bev dish

Do not use existing cables such as RG as it may cause signal loss. Also, be sure that any outdoor connections are made using waterproof F-connectors rated for MHz or greater.

The cable length between the DISH Damage caused by over-tightening is not covered by the limited warranty. Tighten all indoor coaxial cable connections to the receiver only by hand. If you use a wrench, you may over-tighten the connections and damage your equipment. Connect a temporary cable to a peaking meter. Thread the other end of the cable through the LNBF arm and bracket. Attach the LNBFs to the bracket using the included screws.

Do not adjust the skew. Ensure you are peaking the dish using transponder 11 or higher. With the peaking meter still connected, tighten the mast clamp and elevation bolts using the torque values listed in Table 1 on page 6. Re-confirm signal strength after tightening the bolts. Remove the temporary cable used for peaking the dish. Thread the cable s from the receiver s through the LNBF arm and bracket.

Connect a cable from DPP If a Legacy receiver is present, it should be installed last. Connect a cable from the DPP A splitter or other device will not work in this configuration. If you use a wrench, you may over-tighten the connections and damage your equipment Connect the receiver s to the TV s and display the Point Dish screen if not shown, for most receivers, press MENU on the remote control.

Join Our Mailing List. Email Address:. Website design by Solid Cactus. With this kind of setup should get 82, 91, and 97 on one dish too. Connect all 3 Lnbf to Super Mount. Mount has Ruler mark. Hopefully, between reading and looking at the pictures, you'll make it work. First time setup took quite some time to get it figured out.

The LNB on your right will be looking at Sat. Mount the LNBF back to a dish. Mount the middle one to dish just like normal. You will probably have to compromise on signal strength depending on where you are and what you are watching. This is working for Dishnet, , too. But, between and will more close and almost on the same level. If this happens, press the Pound " " button to store the code. The matching mode light will blink 3 times.

Step 5: Press the "Power" button to turn the device back ON. Try some other remote control buttons to make sure that you have found the right code. Step 1: Press and hold the mode button for about 3 seconds.

When all the other mode button backlights come on, release the mode button. Step 2: Press the Pound " " button twice.